Delta Crack Filler EX (CEMENTITIOUS FINE FINISH PLASTER)
DELTA CRACK FILLER is a cement based ready mixed repair to plaster, brick, stone ,wood etc., before painting or other finishes. DELTA FILLER EX provides a smooth finish.
Application :
- Ideal filler for leveling up of walls before tile laying.
- Skimming expanded polystyrene and asbestos for easy painting.
- For filling small cracks in wood work. Defective paint work and pages between floor boards.
- Mixed with mineral wool it can be used for pipe lagging.
- For fixing plaster board panels.
Characteristic :
| Aspect |
Off white powder |
| Composition |
Cement, special additives and mineral fillers |
| Powder density |
1.14 |
| Mixed wet density |
2.0 g/cm3 |
Texture mm using suitable nozzles
Fine
Medium
Coarse |
0.5
1.2
2.36 |
| Coverage kg/m2@ 1mm thickness |
2 |
| Flexural Strength |
>9 MPa at 28 days |
| Pot life hours |
3 – 4 |
Instruction for Use :
Surface Preparation :
Surface must be dry. Remove dust and loose material prior to filling. Damp wood should be allowed to dry and decayed wood should be removed. Scratch smooth surface to give a good key. Do not apply DELTA FILLER EX over sealant or primer.
Mixing and Placing :
Mix 2 parts of DELTA FILLER to one part of water to form a smooth paste. For deep holes and cracks make a thick paste with less water.
For filling wood grains make a thin paste with more water which can be applied with a brush. DELTAFILLER EX has a working time of 3 – 4 hours. It sets completely 2 hours after application
Packing : Packing in 20 kg plastic bag.
Precaution - Health & Safety : As with all chemical products,caution should always be exercised. Protective clothing, such as gloves and goggles, should be worn (see packaging for specific instructions). Treat any splashes to the skin or eyes with fresh water immediately. Should any of the products be accidentally swallowed, do not induce vomiting, but call for medical assistance immediately. Ensure the container is available for the medical attendant to examine any relevant instructions and contents details. Reseal all containers after use and ensure a product is stored as instructed on the safety section of the labeling.
Storage : All materials should be stored under cover and clear of the ground. Protect from all sources of moisture and frost. Rotate stock in order not to exceed the shelf life of 12 months. Wind and direct sunlight must be avoided.
Technical Supports : DELTA provides on site technical assistance and guidance for use of our products. For further information consult DELTA technical services.
|
