DELTA COAT 245 (POLYMER MODIFIED CEMENTITIOUS WATERPROOFING SYSTEM)
DELTA COAT 245 is a two component, acrylic polymer modified Cementations waterproofing coating. Special modified product HSR is available on request. DELTA COAT is based of a cement-modified mortar with Additives and liquid component. Mixed together on site. The product is easy to apply and is used as an effective protective coating on walls and roofs against waterborne salts , weather, chemicals, atmospheric gases and carbonation. It is a non-shrink mortar and dries to form a flexible waterproof membrane.
Scope of use :
- Basement and lift pits.
- Waterproof lining for drinking water reservoirs & Structures.
- Sealing & coating bar holes to ensure water Tightness.
- For swimming pools.
- To provide protection to concrete surfaces from Carbonation and chloride attack.
- Terrace, balconies and bathrooms.
Advantages :
- pre mixed component, just site mixing.
- Easy application by brush or trowel.
- Impermeable, increased frost and salt resistant.
- Excellent damp proofing to porous and non-porous surfaces.
Technical Description :
| Appearance |
White and Grey |
| Power Density g/1 |
1.47 |
| Liquid Density g/1 |
1.04 |
| Mixed Density g/1 |
1.8 |
| Grain Size |
0-0.5mm |
| Adhesion to concrete |
3 N/mm2 |
Adhesion N/mm2
ASTM D4541 28 days |
1 - 2 |
| Coverage m2/kg |
0.5-0.75 |
| Thick coat / m2 |
1 to 1.5kg |
| No. of coats recommended |
2 |
| Resistantance to tearing |
160 kg/cm2 |
| Flexibility of 1.5 film thick |
> 30% |
Instruction for Use :
- The substrate must be perfectly sound, clean, and free from dust and friable matters.
- Damp the substrate with clean water, Metal surfaces should be wire brushed to remove moss, mild dew, loose paint and rust.
- Mix the components A and B with slow speed drill so as to obtain a creamy coating, which can be, applied by a brush. Or add a little pure water to make the mix brush able.
Application : Use a brush or a roller for application. Always damp the surface before coating. Apply the first coat of DELTACOAT with sufficient thickness to plug pores, cracks and holes @1 kg/m2.Apply 2nd and 3rd layers in the proportion on 0.5 to 1kg/m2. For high-pressure areas it is recommended to reinforce the first layer with a fiber mesh (F20).In case of water reservoirs allow to cure for two days.
Packing : As 17.5 kg. (12.5kg powder and 5 kg liquid)
Precaution - Health & Safety : As with all chemical products, caution should always be exercised. Protective clothing, such as gloves and goggles, should be worn (see packing for specific instruction).Treat any splashes to the skin or eyes with fresh water immediately. Should any of the products be accidentally swallowed, do not induce vomiting, but call for medical assistance immediately. Ensure the container is available for he medical attendant to examine any relevant instructions and contents details. Reseal all containers after use and ensure a product is stored as instructed on the safety section of the labeling.
Storage : All materials should be stored under cover and clear of the ground. Protect from all sources of moisture and frost. Rotate stock in order not to exceed the shelf life of 12 months. Wind and direct sunlight must be avoided.
Technical Supports : DELTA provides on site technical assistance and guidance for use of our products. For further information consult DELTA technical services.
|
